Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Engine Control Module: Service and Repair
EEPROM Programming
1. Set-up - Ensure that the following conditions have been met:
-
The battery is fully charged.
-
The ignition is "ON".
-
The Vehicle Interface Module cable connection at the Data Link Connector (DLC) is secure.
2. Program the PCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user's instructions.
3. If the PCM fails to program, proceed as follows:
-
Ensure that all PCM connections are OK.
-
Check the Techline equipment for the latest software version.
-
Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. The replacement PCM must be
programmed.
Functional Check
1. Perform the On-Board Diagnostic System Check.
2. Start the engine and run for one minute.
3. Scan for DTCs using the scan tool.