Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Generator: Service and Repair
Removal and Installation
REMOVAL
Preparation:
-
Battery ground cable
1. Fan belt
-
Loosen lock bolt.
-
Loosen adjust bolt.
2. Wheel and tire assembly, front right
3. Wiring connector
-
Disconnect terminal "B" and connector.
-
From generator, supporting generator assembly by hand.
4. Adjuster
5. Generator fixing bolt
-
Remove the fixing bolt.
6. Generator assembly
-
Take out generator upper side.
INSTALLATION
6. Generator assembly
-
Direct terminal "B" to bottom side and bring generator assembly to the position to be installed.
5. Generator fixing bolt
4. Adjuster
3. Wiring connector
-
Connect harness connector and direct terminal "B" to above side.
2. Wheel and tire assembly, front right
1. Fan belt