Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
27.
Remove and discard the retaining (snap) ring (see figure 14).
28.
Remove the compressor tool and spring seat. Discard the spring seat.
29.
Remove the reverse piston. Discard the inner & outer 0-rings (see figure 15).
30.
Remove the center support bolts.
31.
Remove the center support housing from the adapter case (see figure 16).
32.
Use a plastic hammer if necessary.
IMPORTANT:
The separator plate gaskets will look deformed and are the primary internal leak. If both gaskets are flat, in-place and not torn STOP, replacing
them will not repair the complaint.
NOTE:
Follow normal transmission replacement procedure for warrantable cases.