Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
1. Piston:(4)
a. The lip of the seals must point toward the front of the transmission. Lubricate the lip seal with transmission fluid.
b. Install piston assembly into the third clutch drum. Use installer to protect the outer seal during installation.
-
Third clutch piston installer: J-23084.
2. Springs.(3)
3. Spring seat.(2)
4. Retaining ring:(1)
a. Place retaining ring onto spring seat.
b. Compress the piston springs, using the piston spring compressor.
CAUTION: Do not over-stress the springs and seat. Do not let the spring seat catch in the ring groove. This may cause damage to the spring seat.
^
Install spring seat retaining ring.
^
Remove the piston spring compressor. Spring compressor: J-23075 and Adapter: J-23075-12.