Rodeo LS 2WD V6-3165cc 3.2L SOHC (6VD1) (1997)
Center Support: Service and Repair
TOOLS REQUIRED
^
J-22888 Center Support Bearing Remover
^
Or Equivalent
REMOVAL
1. Lock nut (9) and washer (10) from propeller shaft (3): Clamp front propeller shaft in a soft-jawed vise.
2. End yoke (11) from propeller (3): Apply a reference mark to the end yoke at drive shaft connection. Use a suitable puller.
3. Center support bearing (2) from propeller shaft (3): Use a special tool.
-
Center support bearing remover; J-22888.
NOTE: Clean all parts after removal.
INSTALLATION
1. New center support bearings (2) onto the propeller shaft. Repack the bearing with grease.
2. End yoke (11). Align the reference marks on the end yoke and drive shaft.
3. Washer (10) and lock nut (9).