Rodeo LS 4WD V6-3.2L (1998)
NOTE Be sure to route the harness away from the panel clips. (Figure 7, 8)
10.
Remove the jack and disconnect the original trailer hitch harness power leads that is connected between the rear accessory power outlet and the
accessory power harness connector (B-14).
11.
Connect the female terminal of the sub harness to the male terminal of the original trailer hitch harness.
12.
Fold additional female terminal of the trailer hitch harness over and place foam tape around connections. (Figure 9)
IMPORTANT This connection is a hot power source. Foam tape must cover the connection completely.