Rodeo LS 4WD V6-3.2L (1998)
7.
Temporarily remove the rubber molding and feed the remaining portion of the sub harness between the inner D-pillar panel and the D-pillar to the
jack storage compartment. (Figure 5)
8.
Apply two (2) foam cushion tapes to the sub harness routed behind the speaker basket. This will prevent noise and possible damage to the harness
from vibration of the rear speaker. (Figure 6)
9.
Apply two (2) foam cushion tapes to the upper and lower portions of the D-pillar panel to secure the harness.