Rodeo LS 4WD V6-3.2L (1998)
4. When inserting the piston into the cylinder, use finger pressure only and do not use a mallet or other impact tool, since damage to the cylinder wall
or piston seal can result. Install piston.
5. Apply special grease (approximately 1 g) to the piston and attach the dust boot to the piston and caliper Insert the dust boot ring into the dust boot.
6. Install guide bolt and lock bolt dust boot.
7. Install the dust boot on the support bracket after applying special grease (Approx. 1 g) onto the dust boot inner surface. Also apply special grease
onto the lock bolt and guide bolt setting hole of the support bracket.
8. Install lock bolt and guide bolt and tighten the bolt to the specified torque.
Torque: 44 Nm (32 ft. lbs.)