Rodeo LS 4WD V6-3.2L (1998)
Rear Axle Brake Hose
REMOVAL
1. Raise the vehicle and support it with suitable safety stands.
2. Remove wheel and tire assembly.
3. Clean dirt, grease, and other foreign material off the hose fittings at both ends.
4. Disconnect brake pipe.
5. Remove clip.
6. Remove brake pipe.
7. Remove bolt.
8. Remove hose.
INSTALLATION
To install, follow the removal steps in the reverse order noting the following points.
1. Tighten the brake pipes to the specified torque
Torque: 16 Nm (12 ft. lbs.)
2. Tighten the bolt to the specified torque.
Torque: 15 Nm (11 ft. lbs.)
After installing the brake hoses, bleed the brakes.