Rodeo LS 4WD V6-3.2L (1998)
-
Carefully mount the crankshaft.
-
Apply engine oil to the thrust washer.
-
Assemble the thrust washer to the No.3 bearing journal. The oil grooves must face the crankshaft.
2. Rear oil seal (10)
-
Remove the oil from the cylinder block and the retainer mounting surface.
-
Apply sealant (TB-1207B or equivalent) to the retainer mounting surface, following the pattern shown in the illustration.
The retainer must be installed within 5 minutes after sealant application to prevent premature hardening of sealant.
-
Apply engine oil to the oil seal lip.
-
Align the cylinder block dowel pin holes with the rear retainer dowel pins.
-
Tighten the rear retainer fixing bolts. New bolts should be used when installing rear retainer.
Torque: 18 Nm (13 ft. lbs.)
NOTE: Be very careful not to disengage the oil seal garter spring during installation of the rear retainer.