Rodeo LS 4WD V6-3.2L (1998)
Valve: Service and Repair
Valve Guide Seal
Removal and Installation
REMOVAL
1. Disconnect battery ground cable.
2. Drain engine oil.
-
Drain engine coolant.
3. Remove cylinder head assembly.
Refer to removal procedure for Cylinder Head.
4. Remove camshaft.
Refer to removal procedure for Camshaft.
5. Remove tappets with shim.
NOTE: Do not damage shim surface.
6. Remove valve springs using J-8062 valve spring compressor and J-42898 valve spring compressor adapter then remove upper valve spring seat
and lower seat.
7. Remove oil controller using J-37281 oil controller remover, remove each valve stem oil controller.
8. Remove valve guide using J-37985 valve guide replacer.
INSTALLATION
1. Install valve guide using J-42899 valve guide installer.
2. Install oil controller using J-38537 oil controller installer.
3. Install lower valve spring seat, valve spring and upper valve spring seat then put split collars on the upper spring seat, using J-8062 valve spring
compressor and J-42898 valve spring compressor adapter to install the split collars.
4. Install tappet with shim.
5. Install camshaft assembly.
Refer to installation procedure for Camshaft.
6. Install cylinder head assembly.