Rodeo LS 4WD V6-3.2L (1998)
[NO]
Go to Step 15.
13. a. Visually inspect the fuel supply line and repair any leaks.
b. Was a problem found?
[YES]
Verify repair.
[NO]
Go to Step 14.
14. a. Remove the fuel tank and inspect for leaky hose or in-tank fuel line.
b. Was a problem found?
[YES]
Verify repair.
[NO]
Go to Step 8.
15. a. If the pliers are still clamped to the fuel supply hose, remove the locking pliers.
b. With suitable locking pliers, clamp the fuel return line to prevent fuel from returning to the fuel tank.
c. Run the fuel pump with the Scan Tool.
d. After pressure has built up, remove power to the pump.
e. Does the fuel pressure indicated by the fuel pressure gauge remain constant?
[YES]
Go to Step 11.
[NO]
Go to Step 16.
16. a. Locate and replace any leaking fuel injector(s).
b. Is the action complete?
[YES]
Verify repair.
17. Is the fuel pressure indicated by the fuel pressure gauge above the specified limit?
[VALUES] 376 kPa (55 psi).
[YES]
Go to Step 18.
[NO]
Go to Step 21.
18. a. Relieve the fuel pressure. Refer to the Fuel Pressure Relief.
b. Disconnect the fuel return line from the fuel rail.
c. Attach a length of flexible hose to the fuel rail return outlet passage.
d. Place the open end of the flexible hose into an approved gasoline container.
e. Run the fuel pump with the Scan Tool.
f.
Observe the fuel pressure indicated by the fuel pressure gauge with the fuel pump running.
g. Is the fuel pressure within the specified limits?
[VALUES] 290 - 375 kPa (42 - 55 psi).
[YES]
Go to Step 19.
[NO]
Go to Step 20.
19. a. Locate and correct the restriction in the fuel return line.
b. Is the action complete?
[YES]
Verify repair.
20. a. Visually and physically inspect the fuel rail outlet passages for a restriction.
b. Was a restriction found?
[YES]
Verify repair.
[NO]
Go to Step 11.
21. Is the fuel pressure indicated by the fuel pressure gauge above the specified value?
[VALUES] 0 kPa (0 psi).
[YES]
Go to Step 22.
[NO]
Go to Step 23.
