Rodeo LS 4WD V6-3.2L (1998)
Timing Belt: Service and Repair
Timing Belt Installation
THIS ARTICLE HAS BEEN UPDATED
NOTE:For additional timing belt installation and alignment procedures, see TSB IB00-S005.
NOTE:
- Do not install the timing belt until you are sure the camshafts, camshaft pulleys, and crankshaft timing pulley are in their correct "timed"
positions.
- Left and right engine callouts are from the driver's seat.
1. With the green direction arrows on the timing belt pointing clockwise, slip the belt over the right camshaft pulley so its solid white line (the line
closest to the direction arrows) aligns with the mark on the pulley. Secure the belt to the pulley with a large binder clip.
2. Wrap the timing belt around the bottom of the water pump pulley, and draw it tight.
3. Slip the timing belt over the left camshaft pulley so its other solid white line (the one farthest from the direction arrows) aligns with the mark on
the pulley. Secure the belt to the pulley with a large binder clip.
4. Wrap the timing belt around the inner side of the idler pulley, then slip the belt over the crankshaft timing pulley with its dotted white line aligned
to the green mark on the crankshaft timing pulley.
NOTE:
