Rodeo LS 4WD V6-3.2L (1998)
1.
Locate P-6 ground in the engine compartment on the passenger side of engine compartment between the battery and cruise control actuator (if
equipped). (Figure 1)
2.
Remove P-6 ground terminal bolt for ground contact inspection.
^
Inspect ground contact area for corrosion.
^
Inspect bolt and thread for damage or corrosion.
^
Clean the ground area and fastening bolt thoroughly with a wire brush.
^
Replace bolt if damaged or heavily corroded.
3.
Reinstall the P-6 ground terminal with the above bolt and tighten using hand tools.
^
Torque the P-6 ground terminal bolt to (14 N.m) 10 lb.ft.
IMPORTANT:
Do not use air/power tools when tightening. Over-tightening may occur. Use only hand tools and torque the bolt by hand. Do not over-tighten
or under-tighten the bolt.
ENSURING PROPER P-6 GROUND DURING SAFETY CAMPAIGN 98V-170
1.
Prior to performing Step 5 of SB98-04-L006 (98V-170), the following steps will ensure positive ground contact at P-6 (Figure 2).
^
Inspect ground contact area for corrosion.
^
Inspect bolt and thread for damage or corrosion.