Rodeo LS 4WD V6-3.2L (1998)
A/C Signal: Description and Operation
DESCRIPTION
This signal tells the Powertrain Control Module (PCM) when the A/C mode is selected at the A/C control switch. The PCM uses this signal to
adjust the idle speed before turning "ON" the A/C clutch. The A/C compressor will be inoperative if this signal is not available to the PCM.
OPERATION
A 12-volt signal is supplied to the A/C request input of the Powertrain Control Module (PCM) when the A/C is selected through the A/C control
switch.
The A/C compressor clutch relay is controlled through the PCM. This allows the PCM to modify the idle air control position prior to the A/C
clutch engagement for better idle quality. If the engine operating conditions are within their specified calibrated acceptable ranges, the PCM will
enable the A/C compressor relay. This is done by providing a ground path for the A/C relay coil within the PCM. When the A/C compressor relay
is enabled, battery voltage is supplied to the compressor clutch coil. The PCM will enable the A/C compressor clutch whenever the engine is
running and the A/C has been requested. The PCM will not enable the A/C compressor clutch if any of the following conditions are met:
-
The engine speed is greater than 6315 RPM.
-
The Engine Coolant Temperature (ECT) is greater than 119°C (246°F).
-
The throttle is more than 80% open.
PURPOSE
The A/C compressor operation is controlled by the powertrain control module (PCM) for the following reasons:
-
It improves idle quality during compressor clutch engagement.
-
It improves wide open throttle (WOT) performance.
-
It provides A/C compressor protection from operation with incorrect refrigerant pressures.
The A/C electrical system consists of the following components:
-
The A/C control switch.
-
The A/C refrigerant pressure switches.
-
The A/C compressor clutch.
-
The A/C compressor clutch relay.
-
The PCM.
A/C REQUEST SIGNAL
This signal tells the PCM when the A/C mode is selected at the A/C control switch. The PCM uses this input to adjust the idle speed before turning
on the A/C clutch. The A/C compressor will be inoperative if this signal is not available to the PCM.
