Rodeo LS 4WD V6-3.2L (1998)
Engine Control Module: Service Precautions
Electronic components used in the control system are often designed to carry very low voltage. Electronic components are susceptible to damage
caused by electrostatic discharge. Less than 100 volts of static electricity can cause damage to same electronic components. By comparison, it
takes as much as 4000 volts for a person to even feel the zap of a static discharge. There are several way for a person to become statically charged.
The most common methods of charging are by friction and by induction. An example of charging by friction is a person sliding across a car seat.
Charging by induction occurs when a person with well insulated shoes stands near a highly charged object and momentarily touches ground.
Charge of the same polarity are drained off leaving the person highly charged with opposite polarity. Static charge can cause damage, therefore, it
is important to use care when handling and testing electronic components.
NOTICE: To prevent possible Electrostatic Discharge damage, follow these guidelines:
-
Do not touch the control module connector pins or soldered components on the control module circuit board.
-
Do not open the replacement part package until the part is ready to be installed.
-
Before removing the parts from the package, ground the package to a known good ground on the vehicle.
-
If the parts been handled while sliding across the seat, or while sitting from standing position, or walking a distance, touch a known good
ground before installing the parts.
NOTICE: To prevent Internal PCM damage, the ignition must be OFF position in order to disconnect or reconnect power to the PCM (for
example: battery cable, pig tail, PCM fuse, jumper cable, etc.).
IMPORTANT: When replacing the production POM with service POM, it is important to transfer the broadcast code and production PCM
number to the service P01 label. This will allow positive identification of PCM part throughout the service life of the vehicle. Do not record this
information on PCM metal cover.
IMPORTANT: The ignition should always be in the OFF position in order to install or remove the PCM connectors. Service of the PCM should
normally consist either replacement of the POM or EEPROM reprogramming. If the diagnostic procedures call for the replacement PCM to be
replaced, the PCM should be checked first to ensure it has the correct part number. If it is, remove the faulty PCM and install the new service PCI
The service PCM EEPROM will need to be programmed. Additionally, after programming, the CK Sensor Tooth Error Correction (TEC) Learn
procedure will need to be performed.
