Rodeo LS 4WD V6-3.2L (1998)
Engine Control Module: Service and Repair
Installation Procedure
1. Insert the PCM into the dashboard.
-
Line up the holes in front for the mounting screws.
2. Install the PCM with two screws in the front and one screw at the left rear.
3. Plug the red, white, and blue connectors into the appropriate sockets.
4. Install the front console and lower console.
5. install the transfer knob.
6. Connect the switch connector and install the rear console.
If the PCM is replaced, the new PCM will need to be programmed.
