isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 6962 > < Initial Inspection and Diagnostic Overview
Page 2
background image

Testing and Inspection/Diagnostic and Trouble Code Charts. See: Air Bag Systems/Testing and Inspection/Component Tests and General
Diagnostics/SRS Diagnostic System Check See: Service and Repair

CAUTION:  Refer to "SDM replacement Guidelines" below for important information on SDM replacement in both deployment and non-deployment
crashes.

Wiring Damage

If any SRS wire harness is damaged, it should be replaced. Don't repair SRS. It is replace only.

SRS Connector (Plastic Body and Terminal Metal Pin) Damage

If any connector or terminal in the SRS wire harness (except pigtails) is damaged, it should be replaced.

SRS Wire Pigtail Damage

If the wiring pigtail (a wire or wires attached directly to the device, not by a connector) is damaged, the entire component (with pigtail) must be replaced.
Examples of "pigtail" components are the driver air bag assembly, the passenger air bag assembly, and the SRS coil assembly.

Initial Inspection and Diagnostic Overview|Page 6962 > < Initial Inspection and Diagnostic Overview