Rodeo LS 4WD V6-3.2L (1998)
Wheel Speed Sensor: All Technical Service Bulletins
ABS - Rear Speed Sensor Resistance Value Revision
BULLETIN NUMBER:
SB97-09-L006
ISSUE DATE:
DECEMBER 1997
GROUP:
BRAKES
1998 RODEO (UE) ABS REAR SPEED SENSOR DIAGNOSIS
(Workshop Manual Revision)
AFFECTED VEHICLES
1998 Rodeo (UE) models.
The rear speed sensor diagnosis procedures, contained in Section 5A - Brake Control System of the following Workshop Manual, have been revised.
Manual
Page No.
1998 Rodeo (UE)
5A-24, 47, 50, 54
(Publication No.
UE098-WSM-L01
The nominal resistance values for the rear speed sensor are currently listed as 2.0K to 2.8K ohms. These values should 1.0K to 1.6K ohms. Below is a
summary of the revisions to the affected pages:
Page 5A-24 EHCU Connector Pin-Out Checks
^
Step 6, rear speed sensor nominal value changed from 2.0K to 2.8K ohms to 1.0K to 1.6K ohms.
Page 5A-47 Chart B-19 Rear Speed Sensor Open or Shorted (DTC 53 (Flash out)/C0235 (Serial communications)
^
Step 1, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"
^
Step 2, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"
Page 5A-50 Chart B-22 Rear Speed Sensor Missing (DTC 63 (Flash out)/C0236. C0237 (Serial communications)
^
Step 1, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"
^
Step 3, changed to read: "Is the resistance between 1.0K and 1.6K ohms?"
Page 5A-54 Chart C-1-3 Rear Sensor Output Inspection Procedure
^
Step 2, changed to read: "Is the check between connector (F-4) terminals 1 and 2 within 1.0K - 1.6K ohms?"
