Rodeo LS 4WD V6-3.2L (1998)
-
Set the camshaft marked "RE" and "LE into the exhaust side of the cylinder bank, with "RE" at the 12 o'clock position. Make sure the single
timing dot on the camshaft gear aligns with the timing dot on the camshaft drive gear.
5. Install the left cylinder bank intake and exhaust camshafts:
-
Set the camshaft marked "LI" into the intake side of the head. Make sure the dual timing dots on the camshaft gear align with the timing dot on
the camshaft drive gear.
-
Set the camshaft marked "LE" and "RE," into the exhaust side of the cylinder bank, with "LE" at the 12 o'clock position. Make sure the dual
timing dots on the camshaft gear align with the timing dot on the camshaft drive gear.
6. Install the camshaft bearing caps in the same locations and directions they were before you removed them.
NOTE:
On the right cylinder bank, the directional arrows on the bearing caps should point towards the front of the engine. On the left bank, the arrows
should point towards the rear of the engine.
7. Install the bearing cap bolts, then torque them to 10 N.m (7 lb-ft) in the sequence shown below.
