Rodeo LS 4WD V6-3.2L (1998)
^
Route the existing harness (leading to E-27 connector) in between the (P-8) and (P-9) connections and away from the exhaust manifold.
(Figure 8)
^
(P-9) B+ ring terminal with two (WHT) wires, at the rear of alternator
^
(P-7) Ground terminal, near the alternator, on the frame
NOTE
Clean the ground area and fastening bolt with a wire brush. Replace the bolt if heavily corroded.
4.
Install one band clip near the alternator. (Figures 9 & 10)
