isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

Recall - Engine Ground Point Addendum|Page 5652 > < Engine - MIL ON/High Erratic Idle/Noise|Page 5646
Page 1
background image

Grounding Point: Recalls
Recall - Engine Ground Point Addendum

BULLETIN NUMBER:
SB99-04-S001

ISSUE DATE:
AUGUST 1999

GROUP:
ELECTRICAL

1998 RODEO (UE) / AMIGO (UA) ENGINE GROUND POINT P-6 (ADDENDUM TO SB98-04-L006/SAFETY CAMPAIGN 98V-170)

AFFECTED VEHICLES 
1998 Rodeo (UE), Amigo (UA) V6 models.

SERVICE INFORMATION

Condition:

Some affected vehicles may exhibit one or more of the following conditions:

^

Idle speed flare

^

Flashing ABS light

^

Loss of communication to Tech 2

^

Vehicle Speed Sensor codes (such as P0502)

^

Radio system malfunction

^

Check engine light on and no codes

^

Engine stalling

^

Intermittent no start while cranking

^

In addition, other electrical related conditions may exist, either continuously or intermittently.

Possible Cause:

There may be a poor contact or loss of contact at the P-6 ground location. For vehicles previously serviced for SAFETY CAMPAIGN 98V-170 (refer to
SB98-04-L006), the attaching bolt of the P-6 ground terminal may have been damaged due to over torqueing or cross threading.

Correction:

To correct this condition, follow the procedure outlined in this bulletin for the inspection and correction of the P-6 ground point for proper electrical
contact.

To prevent this condition when servicing the vehicle for SAFETY CAMPAIGN 98V-170, refer to the procedure outlined in this bulletin to ensure proper
bolt installation at the P-6 ground terminal.

SERVICE PROCEDURE

CORRECTING POOR/LOSS OF P-6 GROUND

Recall - Engine Ground Point Addendum|Page 5652 > < Engine - MIL ON/High Erratic Idle/Noise|Page 5646