Rodeo LS 4WD V6-3.2L (1998)
Starter Motor: Component Tests and General Diagnostics
Characteristic Test
For easily confirming the characteristics, conduct the no load test as follows:
Rating as short as 30 seconds requires rapid testing. Fix the starter on the test bench, and wire as shown in illustration. When the switch is closed, the
current flows and the starter runs under no load. At this time, measure current, voltage and speed to check if they satisfy the standard.
Inspection and Repair
Repair or replace necessary parts it extreme wear or damage is found during inspection
Armature
Measure the outer diameter of commutator, and replace with a new one if it is out of the limit.
Standard: 33.0 mm (1.30 in)
Limit: 32.0 mm (1.26 in)