Rodeo LS 4WD V6-3.2L (1998)
IMPORTANT:
The camshaft journal caps are numbered to prevent mis-match mg. However, pay close attention when installing the caps on the even bank cylinders,
because the cap arrows will face the rear of the cylinder head.
16.
Place a small amount of RTV sealer on the head surface where the cap contacts the head surface (Refer to figure 7).
17.
Install the cylinder heads.
IMPORTANT:
When replacing the cylinder head gaskets, be sure to use the correct gasket for each bank.
18.
Torque (64Nm, 47 lb ft) the cylinder head bolts with oil applied to the threads using the following procedure.
Figure 8
IMPORTANT:
Do not re-use the cylinder head bolts.
19.
Install odd bank cam pulley and even bank cam pulley (Torque: 98 Nm, 72 lb ft).
NOTE:
Skip this step if the pulley has not been removed.
20.
Install both head covers and tighten bolts (Torque: 9 Nm, 7 lb ft)
NOTE:
Use only a couple of bolts to register the cover.
21.
Rotate the crankshaft until the mark on the crankshaft sprocket aligns with the mark on the oil pump cover. This will position the # 2 piston at
TDC. (figure 9)
Figure 9
