Rodeo LS 4WD V6-3.2L (1998)
Drive/Propeller Shaft: Service and Repair
Front Propeller Shaft
FRONT PROPELLER SHAFT AND ASSOCIATED PARTS
REMOVAL
1. Raise the vehicle on a hoist.
NOTE: Apply alignment marks on the flange at the front propeller shaft both front and rear side.
2. Remove bolt, nut and washer (Front axle side).
3. Remove bolt, nut and washer (Transfer side).
4. Remove front propeller shaft.
INSTALLATION
NOTE: Never install the shaft assembly backwards. Never insert bar between yoke lugs when tightening or removing bolts. Completely remove the
black paint from the connecting surface of flange coupling on each end of propeller shaft. Clean so that no foreign matter will be caught in between.
1. Align the mark which is applied at removal. Install front propeller shaft and tighten the bolts to the specified torque.
Torque: 63 Nm (46 Ft. lbs.)