Rodeo LS 4WD V6-3.2L (1998)
Seals and Gaskets: Service and Repair
Transfer Case Output Shaft Seal
TRANSFER REAR OIL SEAL AND ASSOCIATED PARTS
REMOVAL
1. Disconnect the rear propeller shaft (1) from the transfer case side.
2. Remove end nut and rear companion flange (2), using the companion flange holder J-8614-11.
3. Use the universal puller to remove the rear companion flange and O-ring.
4. Remove the oil seal from the transfer case.
INSTALLATION
1. Install oil seal and apply engine oil to the oil seal outer surfaces.
2. Apply the recommended grease (BESCO L2) or equivalent to the oil seal lip.