Rodeo LSE 4WD V6-3.2L (2000)
Engine Control Module: All Technical Service Bulletins
PCM - Reprogramming
BULLETIN NUMBER:
IBOO-S002
ISSUE DATE:
JANUARY 2000
GROUP:
INFORMATION
PCM REPROGRAMMING
AFFECTED VEHICLES
All Isuzu built units with reprogrammable PCM.
It is strongly recommended NOT to reinstall the same software or calibration files when reprogramming a Powertrain Control Module. There is no
technical reason that the download files inside the PCM would ever become corrupted after the control module had previously been successfully
programmed. With the 2.2L and 4.3L Hombre, a P0601 (Control Module Read Only Memory) Diagnostic Trouble Code could set in memory and the
MIL could illuminate if the controller memory became corrupted.
After a necessary reprogramming, it is feasible that certain learned values such as fuel trim, IAC learned positions, certain OBD II diagnostic thresholds,
and automatic transmission shift adapts for the engine or transmission might revert back to their original unlearned starting points. As a result, the engine
and transmission may temporarily operate differently until the values are re-learned.