Rodeo S 2WD L4-2.2L (1999)
Wheel Speed Sensor: Service and Repair
Front Wheel Sensor
REMOVAL
1. Remove speed sensor connector.
2. Remove sensor cable fixing bolt (Upper side).
3. Remove sensor cable! fixing bolt (Lower side).
4. Remove the speed sensor cable fixing bolt.
5. Remove speed sensor.
INSPECTION AND REPAIR
1. Check the speed sensor pole piece for presence of foreign materials; remove any dirt, etc.
2. Check the pole piece for damage; replace speed sensor if necessary.
3. Check the speed sensor cable for short or open circuit, and replace with a new one if necessary.
To check for cable short or open, bend or stretch the cable while checking for continuity.
4. Check the sensor ring for damage including tooth chipping, and if damaged, replace the sensor ring assembly.
INSTALLATION
1. Install speed sensor and take care not to hit the speed sensor pole piece during installation.
2. Install speed sensor fixing bolt and tighten the fixing bolt to the specified torque.
Torque: 11 Nm (95 inch lbs.)
3. Install speed sensor cable fixing bolt (Lower side) and tighten the fixing bolt to the specified torque.
