Rodeo S 2WD L4-2.2L (1999)
^
Use proper non-piercing type crimping tool with a 22AWG sized crimp jaw. (Refer to Figures 7 and 8)
11.
Using a heat-gun, apply heat evenly to the joint terminals' heat-shrink cover to fuse with the wire insulator. (Figure 11)
NOTE
^
For proper connection seal, apply even heat until some "oozing" of glue occurs at the ends of the heat-shrink cover. (Figure 12)
^
Excessive localized heat will damage the heat-shrink cover or melt the wire insulator.
12.
Inspect and correct any loose or exposed terminal(s) / bare wire(s) of the sealed crimp connection.
13.
Cover the section of the crimped connections with the plastic wire loom of the vehicle ABS harness, and wrap the entire area with electrical tape.
(Figure 13)
