Rodeo S 2WD L4-2.2L (1999)
i.
Connect the stoplight switch connector.
CHECKING PEDAL TRAVEL
1. Pedal height must be measured after starting the engine and rowing it several times to apply vacuum to the vacuum booster fully.
NOTE: Pedal height must be 95 mm (3.7 inch) or more when about 50 kg (110.25 lbs.) of stepping force is applied.
2. If the measured value is lower than the above range, air existing in the hydraulic system is suspected. Perform the bleeding procedure.
BRAKE PEDAL TRAVEL
Vehicles equipped with the Anti-lock Brake System may be stopped by applying normal force to the brake pedal. Although there is no need to push
the pedal beyond the point where it stops or holds the vehicle, by applying more force the pedal will continue to travel toward the floor.
This extra brake pedal travel is normal.
