Rodeo S 2WD L4-2.2L (1999)
4. Install return spring (5).
5. Adjust pedal free travel.
6. Tighten the steering column fixing bolt (9) (dash panel) to the specified torque.
Torque: 19 Nm (14 ft. lbs.)
7. Tighten the steering column fixing nut (9) (Cross Beam) to the specified torque.
Torque: 20 Nm (14 ft. lbs.)
8. Apply grease to the entire circumference of the Push rod pin (7).
9. Install push rod pin (7).
10. Install snap pin (4).
11. Connect the anti-theft control module connector.
12. Connect the stop light switch connector (3).
13. Install driver knee bolster (10) and lower cover (8).
14. Install the engine hood opening lever.
15. Connect the yellow 3 way SRS connector located under the steering column.
16. Connect the battery "-" terminal cable.
