Rodeo S 2WD L4-2.2L (1999)
Brake Rotor/Disc: Service and Repair
Removal and Installation
DISASSEMBLED VIEW
DISASSEMBLY
1. Before disassembly, jack up the front of vehicle and support frame with jack stands.
2. Remove the two bolts from the rear side of the knuckle arm, then remove the brake caliper, with the brake hose attached. Use a wire to attach the
brake caliper to the upper link.
3. Remove cover bolt.
4. Remove cover.
5. Remove lock washer.
6. Remove hub nut, using front hub nut wrench J-36827.
7. Remove outer bearing.
8. Remove oil seal.
