Rodeo S 2WD L4-2.2L (1999)
3.
Disconnect the top and bottom harness connectors (see figure 1).
4.
Separate the Coil Integrated Module (CIM) from the Hydraulic Unit by removing the Torx screws (see figure 2).
NOTE:
To avoid damaging the Torx screws please remove screws gently.
5.
Clean the Coil Integrated Module (CIM) mounting surface on the Hydraulic Unit with a clean shop towel.
6.
Attach the new Coil Integrated Module (CIM) to the Hydraulic Unit, reattach the Torx screws and torque to 39 lb in. Reinstall the top and bottom
harness connectors.
NOTE:
The Coil Integrated Module (CIM) is not interchangeable between 2WD and 4WD drivetrains. Make sure that a 2WD Coil Integrated Module
is installed only on a 2WD vehicle and a 4WD Coil Integrated Module is installed only on a 4WD vehicle.
7.
After the repair has been completed, reconnect the battery ground terminal.
8.
Start the engine and verify the ABS indicator light comes on then goes out after approximately 5 seconds.
9.
Set the clock and the customers radio settings.
Applying the Campaign Label
