Rodeo S 2WD L4-2.2L (1999)
^
Use proper non-piercing type crimping tool with a 22AWG sized crimp jaw, such as Kent-Moore VA-19730. (Figures 7 and 8)
Use only non-piercing type crimping tool with a 22AWG sized crimp jaw such as above.
9.
Cut the (3) un-terminated ends of the new extension ABS harness wires at a point 50 mm (2") from end of plastic wire loom. Strip the ends of the
wires so that 6-7 mm (1/4") of bare wire is showing. (Figure 9)
10.
While observing the color of the wire insulator RED or ORANGE, WHITE, and BLACK), insert and crimp the matching color wire of the repair
ABS harness to the crimped end of the vehicle ABS harness.
NOTE
^
Do not pierce or damage the heat-shrink insulation of the joint terminals during crimping.
