Rodeo S 2WD L4-2.2L (1999)
Water Pump: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Drain coolant.
3. Radiator hose (on inlet pipe side).
4. Remove timing belt, refer to Timing Belt.
5. Remove water pump assembly.
INSPECTION
Make necessary repair and parts replacement if extreme wear or damage is found during inspection. Should any of the following problems occur, the
entire water pump assembly must be replaced:
-
Crack in the water pump body
-
EC leakage from the seal unit
-
Play or abnormal noise in the bearing
-
Cracks or corrosion in the impeller
INSTALLATION
1. Before installing water pump, coat sealing surface with silicon grease.
2. Install water pump assembly and tighten bolts to the specified torque.
Torque: 25 Nm (18 ft. lbs.)
3. Timing belt
-
Install timing belt, refer to timing belt installation step in Timing Belt.
4. Connect radiator hose and replenish EC.
5. Connect battery ground cable.
