Rodeo S 2WD L4-2.2L (1999)
Intake Manifold: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Remove PCV hose from air intake duct.
3. Remove a nut from air intake duct bracket and loosen hose clamp on throttle body. Remove air intake duct assembly with air cleaner cover.
4. Drain engine coolant.
5. Remove water hoses from throttle body.
6. Disconnect the connector for throttle position sensor, idle air control valve sensor from throttle body.
7. Remove fuel pipe joint eye bolts from fuel rail and disconnect wire harness from fuel injector.
8. Disconnect hose from fuel pressure regulator then remove fuel rail assembly.
9. Remove throttle valve control cable from throttle body.
10. Remove fixing bolts for generator bracket.
11. Remove water pipe fixing bolt then remove water pipe.
12. Remove fixing bolt from bracket (Between cylinder block and intake manifold) of intake manifold side.
13. Remove ignition coil bracket fixing bolt.
