Rodeo S 2WD L4-2.2L (1999)
7. Then loosen the knurled bolt (3) fix the measuring arm at "9 o'clock" again and repeat the measurement.
8. If the value determined in one of the 4 measurements lies outside the tolerance 0.02 mm to 0.06 mm (0.0008 to 0.0024 inch), the tooth backlash
must be adjusted.
9. Remove balance unit from cylinder block/crankshaft bearing caps and remove with balancer piece. The balancer piece has a number (code), for
easy assignment. The tooth backlash can be adjusted by using a balancer piece with a different thickness.
NOTE: The next larger or smaller balancer alters the tooth backlash by 0.02 mm (0.0008 inch).
Example of selection of balancer piece: The installed balancer piece with the code "70" gave a tooth backlash of 0.08 mm (0.0031 inch).
If a balancer piece with the code "67" is now installed, the tooth backlash will be approximately 0.06 mm (0.0024 inch).
CAUTION: Only one balancer piece may be installed.