Rodeo S 2WD L4-2.2L (1999)
Timing Belt: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Move drive belt tensioner to loose side using wrench then remove drive belt.
3. Remove engine harness cover and disconnect three connectors from left rear side of engine compartment.
4. Remove four bolts and remove crankshaft pulley.
5. Disconnect three connectors of engine harness from chassis harness of left rear side of engine compartment.
6. Remove nut and remove engine harness cover from front of engine.
7. Remove two bolts then remove timing belt front cover.
8. Remove fixing bolt of timing belt tensioner then remove timing belt tensioner (1).
9. Remove timing belt.
CAUTION:
- Do not bend or twist belt, otherwise its core could be damaged. The belt should not be bent at a radius less than 30 mm.
