Rodeo S 2WD L4-2.2L (1999)
The surface area must be clean prior to applying the thermal sticker.
13.
Apply thermal sticker onto the left side of the rear cover hole, with minimal coverage on the threaded hole. (Figure 7)
Important:
Thermal sticker must be completely applied on the metal surface only preferably on the left side. Do not cover the bolt hole.
Note:
If the engine is fitted with the old style tensioner, you must replace it with the new style tensioner. The old style tensioner will have a single
V-notch. (Figure 8)
14.
Apply the 65°C setting sticker on the new style tensioner. (Figure 8)
