Rodeo S 2WD L4-2.2L (1999)
31.
Start the engine and let it idle.
32.
Check that the 65°C indicator is green and that the tensioner pointer is operating in the setting window, then turn off the engine. If the 65°C
indicator is brown or black, let the engine idle until the 65°C indicator is green. If the pointer is outside the setting window, then repeat the Final
Tensioner Setting procedure. (Figures 13, 14 and 15)
33.
Install the timing belt cover clip on to the timing belt cover. Pull the timing belt cover seal to install the clip, then reinstall the timing belt seal.
(Figure 16)
Important:
The pre-molded timing belt clip must still be present on the timing belt cover. The timing belt cover will need to be replaced if the clip is
