Rodeo S 2WD L4-2.2L (1999)
Fusible Link
The fusible link is primarily used to protect circuits where high amounts of current flow and where it would not be practical to use a fuse. For example,
the starter circuit. When a current overload occurs, the fusible link melts open and interrupts the flow of current so as to prevent the rest of the wiring
harness from burning.
Determine the cause of the overload before replacing the fusible link. The replacement fusible link must have the same amperage specification as the
original fusible link. Never replace a blown fusible link with fusible link of a different amperage specification. Doing so can result in an electrical fire or
other serious circuit damage.
A blown fusible link is easily identified as shown in the figure.
Fusible Link Specifications
Circuit Breaker
The circuit breaker is a protective device designed to open the circuit when a current load is in excess of rated breaker capacity. If there is a short or
other type of overload condition in the circuit, the excessive current will open the circuit between the circuit breaker terminals. The reset knob (1) pops
out when the circuit is open. Push the reset knob in place to restore the circuit after repairing it.
