Rodeo S 2WD L4-2.2L (1999)
Tires: All Technical Service Bulletins
Tires - Proper Inflation Pressure Information
2006 Service Bulletins
Information IB06-08-S003
Information On Proper Tire Pressure
ISSUE DATE: SEPTEMBER 2006
Affected Vehicles
All Light Duty Isuzu Vehicles
Service Information
IMPORTANT:
Generally a 5.6°C (10° F) temperature change will result in (is equivalent to) a 1 psi (6.9 kpa) tire pressure change. Tires may be over inflated from
the assembly plant due to the mounting process. ALL tires (including the spare tire) MUST be set to the recommended inflation pressure stated on
the vehicles placard during the PRE-DELIVERY INSPECTION.
Ride, handling and road noise concerns may be caused by improperly adjusted tire pressure.
The first step in the diagnosis of these concerns is to verify that the tires are inflated to the correct pressures. The recommended tire inflation pressure is
listed on the vehicle's tire placard. The tire placard is located on the driver's side front or rear door edge, or the rear compartment lid.
Tip
^
Generally a 5.6°C (10°F) temperature change will result in (is equivalent to) a 1 psi (6.9 kpa) tire pressure change.
^
The definition of a "cold" tire is one that has been sitting for at least 3 hours or driven no more than 1.6 km (1 mi).
IMPORTANT:
Do not use the tire pressure indicated on the tire itself as a guide. Always inspect and adjust the pressure when the tires are cold. Vehicles that have
different pressures for the front and the rear need to be adjusted after tire rotation.
Improper tire inflation may result in any or all of the following conditions:
^
Premature tire wear
^
Harsh ride
^
Excessive road noise
^
Poor handling
^
Reduced fuel economy
^
Low Tire Pressure Monitor (TPM) Light ON
^
Low Tire Pressure Message on the Drivers Information Center (DIC)
