Rodeo S 2WD L4-2.2L (1999)
Crankshaft Fluctuation Sensor: Service and Repair
Crankshaft Angle Sensor
REMOVAL
1. Disconnect battery ground cable.
2. Wiring connector from crankshaft angle sensor.
3. Remove crankshaft angle sensor from cylinder block.
INSTALLATION
1. Install crankshaft angle sensor into the cylinder block. Before installation, apply small amount of engine oil to the O-ring.
Torque: 6 N.m (4 lb ft)
2. Reconnect wiring connector to crankshaft angle sensor.
