Rodeo S 2WD L4-2.2L (1999)
Fuel Rail: Service and Repair
Fuel Rail Assembly
REMOVAL
NOTE:
-
Use care when removing the fuel rail assembly in order to prevent damage to the injector electrical connector terminal and the Injector spray tips.
-
Fitting should be capped and holes plugged during servicing to prevent dirt and other contaminants from entering open lines and passage.
NOTE: An eight-digit identification number is stamped on side of the fuel rail. Refer to this number when you service the fuel rail or when a
replacement part is required.
1. Depressurize the fuel system. Refer to Fuel Pressure Relief Procedure.
2. Disconnect the fuel inlet at the rear of the engine.
3. Disconnect the fuel return line at front of the engine.
4. Disconnect the injector electrical connectors.
5. Remove the nuts holding wiring harness onto fuel rail.
6. Remove the bolts retaining fuel rail to the intake manifold.
A. Lift up the injectors carefully to separate them from intake manifold.
B. Lift up the fuel rail with injectors as assembly. Do not separate the fuel injectors from fuel rail.
C. If an injector become separated from fuel rail, injector backup O-ring and injector retainer clip must be replaced.
D. Drain residual fuel from fuel rail into an approved container.
7. If removal of fuel pressure regulator is necessary. Refer to Fuel Pressure Regulator Removal Procedure.