Rodeo S 2WD L4-2.2L (1999)
Throttle Cable/Linkage: Adjustments
Accelerator Cable Adjustment
1. Loosen the adjusting nut.
2. Loosen the jam nut.
3. Pull the outer cable while fully closing the throttle valve.
4. Tighten the adjusting nut.
5. Tighten the jam nut.
6. Loosen the adjusting nut by three turns.
7. Tighten the jam nut again.
8. Manually operate valve.
NOTE: The valve lever must return up to the stopper screw. If the valve lever does not reach the stopper screw, repeat the procedure again from
Step 1.