Rodeo S 2WD L4-2.2L (1999)
Engine Control Module: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect the negative battery cable.
2. Block the wheels.
3. Remove ashtray inner.
4. Remove a screw located behind ashtray.
5. Pull out Face trim of console.
6. Remove two screws located inside of center console storage box and pull up rear part of center console.
7. Unscrew the shift knob.
8. Remove four screw holding front part of the console and pull the console up.
9. Disconnect the red, white and blue electrical connector at the PCM.