Rodeo S 2WD L4-2.2L (1999)
WARNING: The inflator module should always be carried with the urethane cover away from your body and should always be laid on a
flat surface with the urethane side up. This is necessary because a free space is provided to allow the air cushion to expand in the unlikely
event of accidental deployment. Otherwise, personal injury may result.
11. Remove steering column cover.
12. Disconnect the wiring harness connectors located under the steering column.
13. Remove the combination switch assembly with SRS coil.
NOTE: The SRS coil is a part of the combination switch assembly, which can not be replaced separately. Therefore, be sure not to remove the
SRS coil from the combination switch assembly.
14. Remove snap ring.
15. Remove cushion rubber.
16. Remove shift lock cable (for A/T).
17. Disconnect the starter switch harness connector located under the steering column then remove lock cylinder assembly.
INSTALLATION
1. Install lock cylinder assembly.
2. install shift lock cable (for A/T).
3. Install cushion rubber.
4. Install snap ring.
5. Install Combination switch and SRS coil assembly. After installation of combination switch assembly, connect the combination switch wiring
harness connector and the SRS 2-way connector located under the steering column.
