Rodeo S 2WD L4-2.2L (1999)
Electronic Brake Control Module: Service Precautions
The Anti-lock Brake System interfaces directly with the Electronic Hydraulic Control Unit (EHCU) which is a control computer that is similar in
some regards to the Powertrain Control Module. These modules are designed to withstand normal current draws associated with vehicle operation.
However, care must be taken to avoid overloading any of the EHCU circuits. In testing for opens or shorts, do not ground or apply voltage to any of
the circuits unless instructed to do so by the appropriate diagnostic procedure. These circuits should only be tested with a high impedance multimeter
(J-39200) or special tools. Power should never be removed or applied to any control module with the ignition in the "ON" position.
Before removing or connecting battery cables, fuses or connectors, always turn the ignition switch to the "OFF" position.
