isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

ABOUT US
Relays and Modules - Restraint Systems > < Ignition Control Module|Description and Operation|Page 240

Rodeo S 2WD L4-2.2L (1999)

Page 1
background image

Ignition Control Module: Service and Repair

REMOVAL

1. Disconnect battery ground cable.
2. Ignition Module Connector.

3. Removal Ignition Module (1).

INSTALLATION

1. Install the Ignition Module (1).

Connect ignition module connector and ignition coil, then tighten bolt to the specified torque.
Torque: 20 N.m (15lb ft)

2. Connect battery ground cable.

Relays and Modules - Restraint Systems > < Ignition Control Module|Description and Operation|Page 240