Rodeo S 2WD L4-2.2L (1999)
If the coil has been damaged, replace it.
Removal
1. Disable the SRS. (Refer to "Air Bag(s) Arming and Disarming".)
2. Remove air bag assembly from steering wheel by removing two bolts. Lift air bag assembly out of steering wheel.
3. Disconnect connector and remove air bag assembly.
Installation
Installation
1. Connect air bag to wiring harness connector.
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of air bag to prevent lead wire from being pinched.
2. Install air bag into steering wheel and tighten bolts to specified sequence as shown in image.
Torque: 8.8 N.m (78 lb in)
CAUTION: Never use the air bag assembly from another vehicle and difference model year air bag assembly.
The air bag assembly has identification colors on the bar code label from '99 model as follows.
-
White color for driver air bag assembly.
-
Yellow color for passenger air bag assembly.
Use only the air bag assembly for this vehicle.
3. Enable the SRS. (Refer to "Air Bag(s) Arming and Disarming".)
